Senco PC1010 Manuel d'utilisateur télécharger pdf (Page 9)

COMPRESSOR FEATURES

1) MOTOR/PRESSURE SWITCH: This switch is used to start or stop the air

compressor. Moving the switch to the (On) position will provide automatic

power to the pressure switch which will allow the motor to start when the air tank

pressure is below the factory set cut-in pressure. When in the On Position,

the pressure switch stops the motor when the air tank pressure reaches the factory

set cut-out pressure. For safety purposes, this switch also has a pressure release

valve located on the side of the switch designed to automatically release compressed

air from the air compressor pump head and its discharge line when the air compressor

reaches cut-out pressure or is shut off. This allows the motor to restart freely. Moving

the switch to the Off position will remove power from the motor and stop

the air compressor.

2) MOTOR OVERLOAD: Motor has a protective breaker located on the pump.

Excessive amperage draw will result in the breaker tripping to protect the motor

and operator. Reset the breaker by pushing the black plastic stem back into

the housing. Reset switch if it is tripped.

3) AIR INTAKE FILTER:

This filter is designed to clean air coming into the pump. To

ensure the pump continually receives a clean, cool, dry air supply this filter must

always be clean and ventilation opening free from obstructions. The filter can be

removed for cleaning by using warm, soapy water. Rinse the filter and air dry.

4) AIR COMPRESSOR PUMP: To compress air, the piston moves up and down in

the cylinder. On the downstroke, air is drawn in through the air intake valve while

the exhaust valve remains closed. On the upstroke, air is compressed, the intake

valve closes and compressed air is forced out through the exhaust valve, into the

discharge line, through the check valve and into the air tank.

5) SAFETY RELIEF VALVE: This valve is designed to prevent system failures by

relieving pressure from the system when the compressed air reaches a predetermined

level. The valve is preset by the manufacturer and must not be modified in any way.

To verify the valve is working properly, pull on the ring. Air pressure should escape.

When the ring is released, it will reseat.

6) AIR TANK DRAIN VALVE: The drain valve is used to remove moisture from the air

tank(s) after the air compressor is shut off. NEVER attempt to open the drain valve

when more than 10 PSI of air pressure is in the air tank! To open the drain valve,

turn the knob counterclockwise. Tilt tank to ensure that all condensation drains

through valve.

7) AIR TANK PRESSURE GAUGE: The air tank pressure gauge indicates the

reserve air pressure in the air tank (s).

8) OUTLET PRESSURE GAUGE: The outlet pressure gauge indicates the air

pressure available at the outlet side of the regulator. This pressure is controlled

by the regulator and is always less or equal to the air tank pressure.

9) PRESSURE REGULATOR: The air pressure coming from the air tank is

controlled by the regulator knob. Turn the pressure regulation knob clockwise to

increase discharge pressure, and counterclockwise to decrease discharge

pressure. Follow tool operating instructions for recommended pressure range.

10) DISCHARGE LINE: Please note that the discharge line is very hot.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 50 51

Commentaires sur ces manuels

Pas de commentaire

Senco PC1010 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Compresseurs d'air Senco PC1010